Rave-sports Turbo Sled User Manual

Turbo Chute™ Owner’s Manual www.ravesports.com

9 be necessary to check and release the air pressure from your product throughout the day. C A U T I O N DO NOT OVER-INFLATE. Do not exceed 1 PSI i

10 degrees uphill to prevent downhill movement of the Turbo Chute during use. The Inflatable Start Mat should be at the top of the hill and the las

11 Step 3: Lawn Assembly & Positioning Begin by positioning the Splash Pool at the bottom of the hill where there is level ground. This will be

12 To Slide Before sliding, wet the slide surface and underside of turbo sled with water. Sliding on a dry surface can cause burns to the skin or

13 NOTE: Sliding performance on any slope can be enhanced with the following techniques: 1. Increase the volume of water being applied at the top of

14 Troubleshooting Air chambers won’t hold air: • Check to make sure all valves are completely closed. • Check for holes in the slide following t

15 www.ravesports.com RAVE Sports A Revel Match, LLC Company 3325 Labore Road Saint Paul, MN 55110 800.659.0790 February 2012

1 Table of Contents Introduction ... 2 Safety Rules and Information ...

2 Introduction Please take a few minutes to read this manual before assembling and using the product. Although the product is simple to use, this ma

3 Safety Rules and Information • Make sure that everyone who uses the product is provided with and understands these safety rules and information.

4 • DO NOT use while under the influence of drugs or alcohol, which may impair balance and proper judgment. • Use the Turbo Chute only under mature

5 • Ensure pool reservoir attachment is situated on flat ground. NEVER place reservoir on a downward slope. • Over running the pool reservoir may r

6 Product Configurations

7 Assembling your Turbo Chute Step 1: Setup Make sure the slope and surrounding area are free from obstructions. If using into a lake, ensure lak

8 Align valve with hole in the cover of the side rail. Inflate bladder 50% full and check to ensure bladder is not twisted and valve is properly ali